Dismantling a Sectional Sofa and Other Large Furniture

The scrape of a sofa arm against a door jamb is the sound of a trim repair bill, and most of it can be avoided by taking the piece apart first. Junk pickup of large furniture in Redding, CA runs on one rule: find the bolts before the move starts. The figures kept at redding junk pickup myphr treat a sectional as three or four separate pieces, a wardrobe as a frame plus panels, and a bed as rails, slats and a headboard.

Where does a sectional come apart?

Most sectionals are joined by metal brackets underneath, or by plastic clips that slide together. Tipping the piece on its end shows the connection. Releasing the bracket separates the corner from the chaise, and each piece then goes through a door at a manageable weight. Recliner arms have a lever or a pin behind the cushion that frees the mechanism.

How is a wardrobe taken down?

A tall wardrobe or armoire has a back panel held by small nails and side panels held by cam bolts. Emptying it, removing the doors and then the shelves leaves a frame that can be walked down a hall. Particle board does not take a second assembly, so it ends up in a box truck for the landfill rather than a resale listing.

What about beds, mattresses and a box spring?

Bed rails unbolt with a single wrench, and slats lift out. A mattress and box spring are the awkward pieces, since a queen box spring does not bend around a corner on a stairway. Many spring frames can be split in half with a hand saw. Mattress recycling programs want them intact, so splitting is for the dump route only.

How are floors and walls protected?

Corner guards, moving blankets and a runner along the path stop the damage that gets noticed at a rental inspection. Door hinges can be unpinned to gain an inch. Older houses around Palo Cedro and Redding often have plaster walls with little give, so every turn is measured before the piece is lifted.

Where do the pieces end up?

Sound furniture goes to a donation drop. Wood and fabric pieces too worn to sell go onto a box truck or into a dumpster, and the load is weighed at the transfer station in Shasta County. The foam, the springs and the frame are separated when the tipping fee depends on the material.